Calibrated Leak; Fan Washer/Nut/Spacer - Agilent Technologies VS Series Operation Manual

7. Remove old fan.
8. Insert new fan and reinstall the four (4) sets of washer/nut and spacers and tighten front
mounting screw.
9. Reconnect the white fan connector (Figure B-10 on page B-8).
10. Reinstall filter.
B.4 Calibrated Leak
Equipment Required:
M4 Allen Wrench
12 mm Open End Wrench
1. Disconnect the power to back of the unit and unplug.
2. Wait 30 seconds for the high voltage to dissipate.
B-10
VS Series Component Leak Detector
Figure B-13 Fan Washer/Nut/Spacer
Disconnect power from the unit before performing any
WARNING
maintenance procedure that requires physically disconnecting
any part of the system.