Internal Operating Parameters - Agilent Technologies VS Series Operation Manual

Inquiry
?ALL Responds with four lines. Each begins with a <cr><lf>.
The first line reports the ion chamber value.
The second line reports the emission value.
The third line reports the values of the internal calibration and external
calibration offset variables, which are separated by a space.
The fourth line reports the external calibration and internal calibration gain
variables which are separated by a space.
?AZ<0 Reports the status of the Auto-zero < 0 function, ON or OFF.
?CALOK Reports the status of the last external calibration.
?CALINTOK Reports the status of the last internal calibration.
?CPLOCKOUT Reports the status of the control panel lockout feature, ON or OFF.
?CURRDATE Reports the current system date and time in the following format:
Where:
3 is the day of the week (0 = Sunday, 1 = Monday, etc),
05/25/2005 is mm/dd/yyyy (date),
04:19:03.35 is hh/mm/ss/ms (time) and
1 is PM (0=AM, 1=PM, 2=24 hour).
?DISPLAY Reports what the display bar graph is set to, log,lin, or both.
?EMISSION Reports the emission value.
?EXPONENT Reports the current manual-mode exponent with a two-character (minus
followed by one digit) number. The exponent is within the least sensitive range
(as reported by ?RANGE) and the three lower (more negative exponent) ranges.
See also INIT-EXPONENT.
?EXTLEAK Reports the currently stored value of the external standard leak.
?FIL1HOURS Reports the illuminating hours for Filament 1.
?FIL2HOURS Reports the illuminating hours for Filament 2.
?GAIN Reports the current gain value used by the system depending what mode the
system is in.
?INTERNAL-TYPE Reports the internal standard leak option disabled (0) or enabled (1).
?INTEXT Indicates which leak, Internal or External has been selected for use during
calibration.
VS Series Component Leak Detector
Table 4-2 Internal Operating Parameters
3 05/25/2005 04:19:03.35 1
Response
4-5