Switching The Leak Detector On And Off - Agilent Technologies CrossLab CS Operation Manual

Leak Detector

Switching the leak detector On and Off

Agilent CrossLab CS Electronic Leak Detector Operation Manual
Switching the leak detector On
and Off
With the Leak Detector powered off, briefly press and release
Power/Mode button to turn the unit on. The screen will flash the
words Leak Detector for approximately three seconds, then
begin operating.
Figure 2. The initial screen display for the Agilent leak detector.
With the unit powered on, press and hold the Power/Mode
button for three seconds to power down the unit.
Figure 3. The shutdown screen for the Agilent leak detector.
7