Filament Installation: Agilent Helium Leak Detector Model G8610, G8611, Or G8612; Equipment Required For G8610, G8611, Or G8612; Installation Procedure For G8610, G8611, Or G8612; Table 2-1. Equipment Required For G8610, G8611, Or G8612 Models - Agilent Technologies Helium G8610 Series Field Installation Instructions

Vacuum Products Division
2 2 2 2 Filament Installation: Agilent Helium Leak Filament Installation: Agilent Helium Leak
Filament Installation: Agilent Helium Leak Filament Installation: Agilent Helium Leak
Detector Model G8610, G8611, or G8612 Detector Model G8610, G8611, or G8612 Detector Model G8610, G8611, or G8612 Detector Model G8610, G8611, or G8612
The same filament replacement kit is compatible with any model G8610, G8611, or G8612, as well
as legacy Agilent model VS series leak detectors.

2.1 Equipment Required for G8610, G8611, or G8612

The following tools are suggested for assembly.

Table 2-1. Equipment required for G8610, G8611, or G8612 models

Hot Ion Source Replacement Kit (VSFLDHIS)
Slotted screw driver
Metric Allen wrench set (Range 1.5 mm to
10 mm
Needle nose pliers or tweezer
M3 Phillips head screw driver
Torque wrench (must be adjustable to 40 in-
lbs (4.5 N-m) and 90 in-lbs (10.2 N-m))
Digital multimeter (Fluke 187 or equivalent)
NOTE

2.2 Installation Procedure for G8610, G8611, or G8612

For clarity, some items have been omitted from views.
Manual 699910005, Hot Ion Source Replacement
Item Item
Item Item
Inspect the new ion source kit for deformation, damage and filament
coating flaking prior to installation. Do not install if damaged. Touching
the filament under any condition will cause damage.
Spectrometer
Header
Figure 2-1. Covers
Note Note
Note Note
--
Use to remove leak detector covers
--
--
--
--
For resistance and continuity measurements
Page 6