Equipment, General - Agilent Technologies VS Series Operation Manual

Equipment, General

VS Series Component Leak Detectors
Environment of intended use:
Indoors use in an industrial and laboratory installation only.
Altitude up to 2000m
POLLUTION DEGREE 2, Overvoltage Category: I, Class III
(DC powered)
Operating Temperature: +5 °C to +48 °C, Relative
Humidity (RH) up to 80% max. Operating in the top working
range of [-3, -4, -5, -6], avoid operating with a constant
foreline pressure > 500 mTorr at +48° C.
Storage ambient conditions: RH from 0% to 95%,
non-condensing, temperature: -20°C to +60°C
Do not use in presence of flammable or explosive gas.
WARNING
Do not attempt to disassemble or modify the equipment.
Such action could lead to electric shock or injury. Agilent's
authorized technician will do any repair work.
If there is smoke or unusual smell or noise, stop the using the
equipment immediately, and contact the Agilent Service
Center.
The leak detector is not designed for use with hazardous gases.
WARNING
Verify that the system to be tested has been purged of all
hazardous gases prior to using the leak detector. When testing a
system that contained hazardous gases, connect the exhaust of
the leak detector to a scrubbed or toxic containment exhaust.
Exposure to hazardous gases could result in serious injury or
death.
Equipment tightness is guaranteed for normal operating
WARNING
conditions when the equipment leaves the factory. It your
responsibility to maintain the level of tightness, particularly
when pumping dangerous products.
The performance and operating safety of this equipment can
CAUTION
only be guaranteed if it is operated according to normal
conditions of use.
Allow at least 4" of clearance adjacent to the ventilation slots at
the front, sides and back of the equipment enclosure.
Allow sufficient room for the operator to safely maneuver to
perform testing.
xviii