Unit Top Screws; Turbo Vent - Agilent Technologies VS Series Operation Manual

VS Series Component Leak Detector
3. Use an M4 Allen wrench to remove the two screws on the unit's top and open the unit
(Figure B-74).
4. If the unit was just running, either:
Open the turbo vent valve, if the internal calibrated leak option was not installed
(Figure B-75),
Or crack the NW16 connection (Figure B-76) on the calibrated leak to bring the
turbo to a controlled stop.
Figure B-74 Unit Top Screws
Figure B-75 Turbo Vent
B-51