Mls Qos Vlan-Based - Cisco Catalyst 3560-X Command Reference Manual

mls qos vlan-based

mls qos vlan-based
Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
Examples
Related Commands
Catalyst 3750-X and 3560-X Switch Command Reference
2-400
Downloaded from www.Manualslib.com
Use the mls qos vlan-based interface configuration command on the switch stack or on a standalone
switch to enable VLAN-based quality of service (QoS) on the physical port. Use the no form of this
command to disable this feature.
mls qos vlan-based
no mls qos vlan-based
There are no arguments or keywords.
VLAN-based QoS is disabled.
Interface configuration
Release Modification
12.2(53)SE2 This command was introduced.
Before attaching a hierarchical policy map to a switch virtual interface (SVI), use the mls qos
vlan-based interface configuration command on a physical port if the port is to be specified in the
secondary interface level of the hierarchical policy map.
When you configure hierarchical policing, the hierarchical policy map is attached to the SVI and affects
all traffic belonging to the VLAN. The individual policer in the interface-level traffic classification only
affects the physical ports specified for that classification.
For detailed instructions about configuring hierarchical policy maps, see the "Classifying, Policing, and
Marking Traffic by Using Hierarchical Policy Maps" section in the software configuration guide for this
release.
This example shows how to enable VLAN-based policing on a physical port:
Switch(config)# interface gigabitethernet2/0/1
Switch(config-if)# mls qos vlan-based
You can verify your settings by entering the show mls qos interface privileged EXEC command.
Command
show mls qos interface
manuals search engine
Chapter 2
Description
Displays QoS information.
Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
OL-21522-02