Removing The “Paper Guide,Upper”; Removing The Pe Sensor; Removing The Pe Sensor Holder - Epson Stylus Pro 4910 Service Manual

Epson Stylus Pro 4900/Epson Stylus Pro 4910
25. Lift the "PAPER GUIDE,UPPER" to disengage the dowels on the wight and left
from the main body frame.
26. Move the "PAPER GUIDE,UPPER" to the rear, and pull out the dowels on the
right and left downward from the hole of the main body frame.
"PAPER GUIDE,UPPER"
Figure 3-106. Removing the "PAPER GUIDE,UPPER"
27. Disengage the hooks, and remove the PE Sensor Holder.
Hooks
Figure 3-107. Removing the PE Sensor Holder
DISASSEMBLY & ASSEMBLY
Dowels
PE Sensor Holder
Disassembly and Assembly Procedure
28. Disengage the hooks that secure the PE Sensor Cover, and remove the PE Sensor
Cover.
29. Take out the PE Sensor from the PE Sensor Holder, and disconnect the FFC.
Be sure to refer to Chapter 4 "Adjustment"
A D J U S T M E N T
R E Q U I R E D
specified adjustments after replacing the PE Sensor.
<Adjustment items>
1. Sensor Check (PE Sensor)
2. Rear AD Adjustment
PE Sensor
FFC
PE Sensor Holder
Figure 3-108. Removing the PE Sensor
Revision A
(see p277) and perform
PE Sensor Cover
Hooks
191
Confidential