Setup Menu; Printer Setup Menu; Menu Mode Settings List - Epson Stylus Pro 4910 Service Manual

Epson Stylus Pro 4900/Epson Stylus Pro 4910

1.5.1 Setup Menu

1.5.1.1 Printer Setup Menu

Menu Menu Item
Platen Gap
Page Line
Roll Paper Margin
Paper Size Check
Printer Setup
Paper Skew Check
Refresh Margin
Auto Nozzle Check
Print Nozzle Pattern
Change Black Ink
PRODUCT DESCRIPTION
Table 1-5. Menu Mode Settings List
Settings
(shaded one is the default)
Narrow
Standard
Sets the platen gap (gap between the printhead and the platen).
Wide When the "Others" is selected in the Paper Type of the Paper Setup menu, the platen gap designated at the Custom Paper menu has a
priority over the setting made here.
Wider
Widest
On Sets whether to print a page line (line for manual cutting) on roll paper or not. The page line is printed when On is selected.
The vertical line may be printed when the roll paper width that is set in the printer driver is smaller than the width of the roll paper that
Off
is loaded in the printer. This setting is available for roll paper only.
Default
Top/Bottom 15mm
Sets the margins for roll paper.
Top 35/Bottom 15mm
When the Default is selected, the top and the bottom margins become 15mm and the right and the left margins become 3mm.
3mm
15mm
On Sets whether to detect the paper width and the top or not.
Setting to Off deactivates the sensor that detects the paper width when paper is loaded on the printer. This allows the user to use paper
whose width is out of the sensor's detectable range. It means that the user can print an image larger than the paper size. The user should
Off
know that doing so soils the platen and may cause a print quality or any other trouble.
On This setting is effective for roll paper only.
Sets whether to detect the paper skew or not.
Setting to Off does not carry out the detection and printing is continued even if the paper is skewed. When this setting is set to Off, the
Off
user should have known the risk.
This setting is not available for cut sheet because the skew detection function after printing is not provided for cut sheet.
On
This setting is available only when roll paper is used.
When this is set to On, the top edge area of paper soiled by the previous borderless printing is automatically cut off.
Off
On: Periodically
Sets the execution timing for the auto nozzle check. When the nozzle clogging is detected, the cleaning starts automatically. You can
On: Every Job
set the number of executions for cleaning from
Off
Off
The printer prints a nozzle check pattern automatically at the specified timing. This setting is available only when roll paper is used.
On: Every Page When the set number of pages is reached, the nozzle check pattern is printed on the top of the page. The counter for counting the pages
is not reset even by power-off. When this setting is changed, the counter is cleared.
On: Every 10 Pages
Off
When this is set to ON and the type of the black ink differs between the printer and the printer driver, the black ink of the printer is
changed automatically in printing.
On
Control Panel
Explanation
("PG Settings List" on page 40)
"1.5.2 Maintenance Mode (p42)".
Revision A
34
Confidential