Printer Cover Sensor; Removing The Upper Front Cover - Epson Stylus Pro 4910 Service Manual

Epson Stylus Pro 4900/Epson Stylus Pro 4910

3.4.2.2 Printer Cover Sensor

1. Remove the Front Cover. (p142)
2. Remove the Right Upper Cover.
3. Remove the Control Panel Cover.
4. Remove the Right Cover. (p139)
5. Remove the Left Cover. (p137)
6. Remove the three screws that secure the upper front cover.
A) Silver, Phillips, Bind S-tite with S.W & P.W. M4x10: three pieces
7. Lift the lower right of the upper front cover to release the tab.
8. Lift the upper left of the upper front cover to release the dowel.
When removing the upper front cover in the following steps, pull it
C H E C K
P O I N T toward you taking care not to hit the protrusion on the bottom
against the main frame.
Main frame
9. Pull the part of the upper front cover circled in the figure outward and lift it in the
direction of the arrow to release the dowel.
10. While pushing the Cutter Cover and releasing the contact with the upper front
cover, lift the upper front cover to release the ribs, and remove the upper front
cover.
DISASSEMBLY & ASSEMBLY
(p138)
(p136)
protrusions
Disassembly and Assembly Procedure
Step8
Dowel
A
Step9
Dowel
Figure 3-30. Removing the upper front cover
Revision A
Step7
Tab
A
A
Upper front cover
Cutter Cover
Step10
Interference part
Ribs
134
Confidential