Mac Address Check & Input - Epson Stylus Pro 4910 Service Manual

Epson Stylus Pro 4900/Epson Stylus Pro 4910
4.14.4 MAC Address Check & Input
EXECUTION MODE
Normal Mode
PROCEDURE
1. Connect the printer to the computer with USB cable and network cable together.
2. Turn the printer ON.
3. Start the Service Program and select
Figure 4-99. [MAC Address Check & Input] Screen
ADJUSTMENT
MAC Address Check & Input.
Boards Related Checks and Adjustments
4. Enter the MAC address indicated on the MAC address label attached on the Board
Tray, and click [Write].
Click the [Write] button only once. It takes about two and a half
C A U T I O N
minutes to restart the network firmware, so wait for a while until
the firmware restarts, then move on to the next step.
MAC address label
Figure 4-100. MAC address label
5. Click [Read].
The written MAC address is displayed in about two minutes.
6. Confirm the displayed MAC address and the address on the label are the same.
7. Click [Finish].
8. Turn the printer OFF to complete the adjustment.
Revision A
Front Cover
388
Confidential