Disconnecting The Connector - Epson Stylus Pro 4910 Service Manual

Epson Stylus Pro 4900/Epson Stylus Pro 4910
3.4.2.7 Left IC Cover Frame/Right IC Cover Frame/
Left IC Sensor/Right IC Sensor
Basically you can remove these parts on the left and the ones on the
C H E C K
P O I N T right in the same way. Therefore this section describes the way to
remove the parts on the right only. However, the parts that have to
be removed before removing these parts differ.
Left IC Cover
Front Cover (p142)
•
Right Upper Cover
•
Control Panel Cover
•
Right Cover (p139)
•
• Left Cover (p137)
• Media Eject Cover
Right IC Cover
• Front Cover (p142)
• Right Upper Cover
• Control Panel Cover
Right Cover (p139)
•
DISASSEMBLY & ASSEMBLY
(p138)
(p136)
(p148)
(p138)
(p136)
Disassembly and Assembly Procedure
1. Open the Right IC Cover.
2. Disconnect the connector of the Right IC Sensor, and release the harness from the
cable guides.
Figure 3-38. Disconnecting the connector
Revision A
Connector
Right IC Cover Frame
Cable guide
Confidential
140