Epson Stylus Pro 4910 Service Manual page 71

Epson Stylus Pro 4900/Epson Stylus Pro 4910
Code Error Name
ILS control error has occurred.
1FC9 ILS error (8) Cartridge Holder Board failure
Main Board failure
ILS control error has occurred.
1FCA ILS error (9) Cartridge Holder Board failure
Main Board failure
ILS control error has occurred.
1FCB ILS error (10) Cartridge Holder Board failure
Main Board failure
NVRAM error NVRAM erase or write error has occurred.
2000
Any value cannot be input when accessing SDRAM to write
2002 SDRAM error
the value.
1. Installation of the firmware has been failed.
FLASH BOOT SUM
2003
CHECK error
2. The Flash ROM is damaged.
200A F/W load error Reading/decompressing the firmware has been failed.
System interrupt
A system failure such as CPU failure, defective cash or the like
watchdog time-out
200D
has occurred.
error
TROUBLE SHOOTING
Cause
Remedies for Service Call Error
Check Item
1. Replace the Cartridge Holder.
---
2. Replace the Main Board.
1. Replace the Cartridge Holder.
---
2. Replace the Main Board.
1. Replace the Cartridge Holder.
---
2. Replace the Main Board.
Replace the Main Board.
---
P.152)
Replace the Main Board.
---
P.152)
1. Re-install the firmware.
---
2. Replace the Main Board.
1. Re-install the firmware.
---
2. Replace the Main Board.
Replace the Main Board.
---
P.152)
Revision A
Remedy
(Check both right/left ones
respectively.) (See P.239)(See
P.242)
(See
P.152) *
(Check both right/left ones
respectively.) (See P.239)(See
P.242)
(See
P.152) *
(Check both right/left ones
respectively.) (See P.239)(See
P.242)
(See
P.152) *
(See
*
(See
(See
P.307)
(See
P.152)
(See
P.307)
(See
P.152)
(See
72
Confidential