Removing The Retard Roller - Epson Stylus Pro 4910 Service Manual

Epson Stylus Pro 4900/Epson Stylus Pro 4910
9. Pull up the "HOLDER,RETARD" as shown in the figure and remove it.
"HOLDER,RETARD"
Figure 3-133. Removing the "HOLDER,RETARD"
DISASSEMBLY & ASSEMBLY
10. Release the "HOLDER,RETARD,ASSIST" from the dowels of the
"HOLDER,RETARD".
11. Remove the Retard Roller from the "HOLDER,RETARD".
A D J U S T M E N T
R E Q U I R E D
Disassembly and Assembly Procedure
"HOLDER,RETARD"
D-cut
Dowels
Figure 3-134. Removing the Retard Roller
The shape of the shaft of the Retard Roller is D-cut. When
installing the shaft, be sure to conform it to the shape of the hole of
the "HOLDER,RETARD".
Be sure to refer to Chapter 4 "Adjustment"
specified adjustment after replacing the Retard Roller.
<Adjustment item>
Counter Reset (Retard Roller Counter)
Revision A
Retard Roller
"HOLDER,RETARD,ASSIST"
(see p277) and perform
210
Confidential