Sub-D Board - Epson Stylus Pro 4910 Service Manual

Epson Stylus Pro 4900/Epson Stylus Pro 4910

3.4.3.8 SUB-D Board

1. Remove the Right Roll Cover. (p151)
2. Disconnect all the connectors and FFCs on the SUB-D Board.
When installing the SUB-D Board, be sure to refer to Chapter 6
"Appendix" (see p432)
- Right side -
Figure 3-71. Disconnecting the connectors
DISASSEMBLY & ASSEMBLY
and connect the connectors correctly.
SUB-D Board
Disassembly and Assembly Procedure
3. Remove the four screws that secure the SUB-D Board, and remove the SUB-D
Board.
A) Silver, Phillips, Bind machine screw M3x6: four pieces
Secure the SUB-D Board together with the grounding plate using
the same screw shown in the figure.
- Right side -
A
SUB-D Board
Figure 3-72. Removing the SUB-D Board
Revision A
A
A
A Screw together
Confidential
164