Epson Stylus Pro 4910 Service Manual page 261

Epson Stylus Pro 4900/Epson Stylus Pro 4910
3.4.11.6 Magnet Latch
1. Remove the Color Measurement Device.
2. Remove the Mounter. (p132)
3. Remove the Upper Cover. (p257)
4. Remove the Right Cover. (p259)
5. Remove the Front Cover. (p261)
6. Remove the screw that secures the Housing, Lower, SPM.
A) Silver, Phillips, Round Washer Head S-tite M3x8: one piece
7. While lowering the Housing, Lower, SPM, slide the Housing, Front, Outer, SPM
in the direction of the arrow to remove it. (Housing, Front, Outer, SPM is secured
with the four dowels.)
Housing, Front, Outer, SPM
Figure 3-203. Removing the Housing, Front, Outer, SPM
DISASSEMBLY & ASSEMBLY
(p255)
Housing, Lower, SPM
Housing, Lower, SPM
A
Dowels
Disassembly and Assembly Procedure
In the next step, make sure to confirm which screw is attached to
C H E C K
which location because various screws are used here.
P O I N T
8. Remove the six screws that secure the Housing, Front, Inner, SPM.
B) Silver, Phillips, Round Washer Head S-tite M3x8: five pieces
C) Silver, Phillips, Bind P-tite M3x8: one piece
9. Remove the Housing, Front, Inner, SPM.
Magnet Latch
Figure 3-204. Removing the Housing, Front, Inner, SPM
Revision A
Housing, Front, Inner, SPM
B
C
262
Confidential