Power Supply Box; Pulling Out The Power Supply Box - Epson Stylus Pro 4910 Service Manual

Epson Stylus Pro 4900/Epson Stylus Pro 4910

3.4.3.3 Power Supply Box

1. Remove the Front Cover. (p142)
2. Remove the Rear Cover. (p144)
3. Remove the Left Cover. (p137)
4. Disconnect all the connectors and FFCs on the SUB-C Board.
When installing the SUB-C Board, be sure to refer to Chapter 6
"Appendix" (see p432)
5. Release the harnesses from the three clamps.
6. Remove the four screws that secure the Power Supply Box.
A) Silver, Phillips, Round Washer Head S-tite M3x6: four pieces
7. Pull out the Power Supply Box.
DISASSEMBLY & ASSEMBLY
and connect the connectors correctly.
Disassembly and Assembly Procedure
- Rear left -
SUB-C Board
Power Supply Box
Clamp
A
Figure 3-61. Pulling out the Power Supply Box
Revision A
Clamps
A
- Left side -
A
157
Confidential