Removing The Holder And The Lever - Epson Stylus Pro 4910 Service Manual

Epson Stylus Pro 4900/Epson Stylus Pro 4910
14. Remove the screw that secures the holder, and remove the holder and the lever.
B) Silver, Phillips, Round Washer Head S-tite M3x8: one piece
Lever
Holder
Figure 3-136. Removing the holder and the lever
Make sure to reassemble the holder and the lever as shown below
before installation.
Lever
DISASSEMBLY & ASSEMBLY
B
Holder
Disassembly and Assembly Procedure
15. Disconnect the connector (CN221) from the SUB-B Board.
16. Release the harness from the saddle and the two clamps.
CN221
Figure 3-137. Releasing the harness
Revision A
Clamp
Clamp
Saddle
Confidential
212