Apg Sensor; Removing The Apg Sensor; Rotating The Shading Plate - Epson Stylus Pro 4910 Service Manual

Epson Stylus Pro 4900/Epson Stylus Pro 4910

3.4.4.7 APG Sensor

1. Remove the Front Cover. (p142)
2. Remove the Right Upper Cover.
3. Remove the Control Panel Cover.
4. Remove the Right Cover. (p139)
5. Remove the CR Cover. (p149)
6. Rotate the gear until the cutout of the shading plate comes between the
transmission position of sensor as shown in
Transmission position of sensor
Shading plate
Cutout
Figure 3-90. Rotating the shading plate
DISASSEMBLY & ASSEMBLY
(p138)
(p136)
Figure 3-90.
Gear
Disassembly and Assembly Procedure
7. Disengage the four hooks that secure the APG Sensor, and remove the APG
Sensor.
APG Sensor
Figure 3-91. Removing the APG Sensor
8. Disconnect the connector from the APG Sensor.
APG Sensor
Figure 3-92. Disconnecting the connector
Revision A
Hooks
Connector
Confidential
180