Roll Unit Sensor - Epson Stylus Pro 4910 Service Manual

Epson Stylus Pro 4900/Epson Stylus Pro 4910
3.4.7 ROLL Unit

3.4.7.1 Roll Unit Sensor

1. Remove the Front Cover. (p142)
2. Remove the Right Upper Cover.
3. Remove the Control Panel Cover.
4. Remove the Right Cover. (p139)
5. Remove the screw that secures the sensor holder, and remove the sensor holder.
A) Silver, Phillips, Bind P-tite M3x8: one piece
- Rear right -
Sensor holder
Figure 3-143. Removing the sensor holder
DISASSEMBLY & ASSEMBLY
(p138)
(p136)
A
Disassembly and Assembly Procedure
6. Disengage the hooks that secure the Roll Unit Sensor, and remove the Roll Unit
Sensor.
7. Disconnect the connector from the Roll Unit Sensor.
- Rear right -
Routing
Connector
Figure 3-144. Removing the Roll Unit Sensor
When installing the Roll Unit Sensor, make sure to route the
harness correctly as shown in
Revision A
Roll Unit Sensor
Hooks
Figure 3-144.
Confidential
216