Retard Roller - Epson Stylus Pro 4910 Service Manual

Epson Stylus Pro 4900/Epson Stylus Pro 4910

3.4.6.5 Retard Roller

1. Remove the Rear Unit. (p145)
2. Remove the Rear Cover. (p144)
3. Push and disengage the hook that secures the "CAM,ROLLER,ASSIST".
4. Slide the "CAM,ROLLER,ASSIST" to the right to remove it.
Hook
Hook
Figure 3-131. Removing the "COVER,SHAFT,RETARD,RESET"
5. Remove the screw that secures the "COVER,SHAFT,RETARD,RESET".
A) Silver, Phillips, Round Washer Head S-tite M3x8: one piece
DISASSEMBLY & ASSEMBLY
"CAM,ROLLER,ASSIST"
Disassembly and Assembly Procedure
6. Remove the "COVER,SHAFT,RETARD,RESET".
7. Remove the two springs.
8. Pull the "SHAFT,RETARD,RESET" frontward to remove it.
"SHAFT,RETARD,RESET"
Springs
Figure 3-132. Removing the "SHAFT,RETARD,RESET"
When installing the "SHAFT,RETARD,RESET", be sure to insert
the projection on the left end into the hole of the main frame.
Projection
Revision A
"COVER,SHAFT,RETARD,RESET"
A
"SHAFT,RETARD,RESET"
Main frame
209
Confidential