Epson Stylus Pro 4900/Epson Stylus Pro 4910
3.4.2.3 Control Panel Cover
1.
Remove the Front Cover.
(p142)
2.
Remove the two screws that secure the Control Panel Cover.
A) Silver, Phillips, Round Washer Head S-tite M3x6: two pieces
3.
Pull the Control Panel Cover frontward to release the two dowels, and remove the
Control Panel Cover.
Dowels
A
Dowels
Figure 3-33. Removing the Control Panel Cover
DISASSEMBLY & ASSEMBLY
Control Panel Cover
A
Disassembly and Assembly Procedure
4.
Release the FFC from the clamp, and disconnect the FFC from the connector of
the Control Panel Board.
5.
Peel off the tape.
6.
Pull out the FFC from the ferrite core.
Tape
Connector
Control Panel Cover
Figure 3-34. Removing the FFC
When installing the Control Panel Cover, restore the original
routing (ferrite core and tape) for noise protection purposes.
Tape
Revision A
FFC
Ferrite core
Clamp
Confidential
136