Cutter Hp Sensor; Removing The Cover Holder - Epson Stylus Pro 4910 Service Manual

Epson Stylus Pro 4900/Epson Stylus Pro 4910

3.4.8.3 Cutter HP Sensor

1. Remove the Front Cover. (p142)
2. Remove the Control Panel Cover.
3. Remove the Right Upper Cover.
4. Remove the Right Cover. (p139)
5. Remove the Left Cover. (p137)
6. Remove the Media Eject Cover.
7. Disconnect the connector (CN315) from the SUB-C board.
8. Release the harnesses from the four clamps and the saddle.
9. Pull out the harnesses from the hole of the main body frame.
Clamp
Hole
CN315
SUB-C Board
Figure 3-157. Releasing the harnesses
DISASSEMBLY & ASSEMBLY
(p136)
(p138)
(p148)
Saddle
Clamps
Disassembly and Assembly Procedure
10. Move the cutter to the center.
11. Open the Cutter Cover.
12. Remove the screw that secures the cover holder, and remove the cover holder.
A) Silver, Phillips, Bind P-tite M3x8: one piece
Cover holder
Step 11
Cutter Cover
Figure 3-158. Removing the cover holder
When installing the cover holder, be sure to set the two hooks to the
holes of the main frame.
Cover holder
Revision A
Step 10
A
Cutter
Holes
Hooks
Confidential
226