Thermistor; Removing The Thermistor - Epson Stylus Pro 4910 Service Manual

Epson Stylus Pro 4900/Epson Stylus Pro 4910

3.4.12.3 Thermistor

1. Remove the Color Measurement Device.
2. Remove the Mounter. (p132)
3. Remove the Upper Cover. (p257)
4. Remove the I/F Cover. (p258)
5. Remove the Left Cover. (p260)
6. Disconnect the connector (CN11) from the Main-C Board.
Use tweezers or a similar tool to connect the connector (CN11).
7. Release the harness from the clamp, tape, and cable guide.
Make sure to route the harness correctly as shown in
When removing the Thermistor in the next step, make sure to hold
C A U T I O N
it by both sides together.
Thermistor
8. Remove the Thermistor.
DISASSEMBLY & ASSEMBLY
(p255)
Figure 3-209.
Disassembly and Assembly Procedure
Routing
Thermistor
Cable guide
Figure 3-209. Removing the Thermistor
Be sure to refer to Chapter 4 "Adjustment"
A D J U S T M E N T
R E Q U I R E D
specified adjustment after replacing or removing the Thermistor.
<Adjustment item>
Spectroproofer Sensor Check
Revision A
CN11
Tape
Clamp
(see p277) and perform
267
Confidential