Paper Thickness Sensor1, 2 - Epson Stylus Pro 4910 Service Manual

Epson Stylus Pro 4900/Epson Stylus Pro 4910

3.4.5.9 Paper Thickness Sensor1, 2

1. Remove the Front Cover. (p142)
2. Remove the Right Upper Cover.
3. Remove the Control Panel Cover.
4. Remove the Right Cover. (p139)
5. Remove the Left Cover. (p137)
6. Remove the Printer Cover. (p133)
7. Remove the two screws that secure the upper rear cover, and remove the upper
rear cover.
A) Silver, Phillips, Round Washer Head S-tite M3x8: two pieces
-Upper
A
Figure 3-113. Removing the upper rear cover
DISASSEMBLY & ASSEMBLY
(p138)
(p136)
A
Upper rear cover
Disassembly and Assembly Procedure
8. Mark the screw positions.
Securing the Paper Thickness Sensor at the marked position makes
the subsequent position adjustment easier.
9. Loosen the two screws.
A) Silver, Phillips, Round Washer Head P-tite M3x8: two pieces
10. Remove the sensor holders from the sensor mounting plate.
- Upper right -
Figure 3-114. Removing the sensor holders
Revision A
Sensor holders
A A
Markings
Sensor mounting plate
Confidential
195