Mid-Right Cover/Mid-Left Cover; Removing The Mid-Right Cover - Epson Stylus Pro 4910 Service Manual

Epson Stylus Pro 4900/Epson Stylus Pro 4910

3.4.2.16 Mid-Right Cover/Mid-Left Cover

Basically you can remove this part on the left and the one on the
C H E C K
right in the same way. Therefore this section describes the way to
P O I N T
remove the one on the right only.
1. Remove the Front Cover. (p142)
2. Remove the Right Upper Cover.
3. Remove the Control Panel Cover.
4. Remove the Right Cover. (p139)
5. Remove the Rear Unit. (p145)
6. Release the two hooks and two dowels that secure the Mid-Right Cover from the
main body frame.
7. Remove the Mid-Right Cover.
When installing the Mid-Right Cover, be sure to align the end of
the cover (guide) shown in the figure with the "PAPER
GUIDE,ROLL,UNDER". After the installation, check that the
hooks and the dowels are set securely.
Mid-Right Cover
DISASSEMBLY & ASSEMBLY
(p138)
(p136)
"PAPER GUIDE,ROLL,UNDER"
Guide
Disassembly and Assembly Procedure
Mid-Right Cover
Dowels
Figure 3-52. Removing the Mid-Right Cover
Revision A
Hooks
150
Confidential