Icom ID-4100A Advanced Manual page 111

Previous view
5
GPS OPERATION
Adding or editing GPS memory
D Add a GPS memory (Continued)
3. Entering the GPS Memory date
1. Select "DATE," then push [ï].
• Enters the date entry mode.
2. Push [MW] to move the cursor forwards, or push
[MODE] to move the cursor backwards to select a
digit to enter.
3. Rotate [DIAL] to enter the date.
• Range: Set to between 2000/01/02 and
2099/12/30.
4. Repeat steps 2 and 3 to enter the date.
5. After entering, push [ï].
4. Entering the GPS Memory time
1. Select "TIME," then push [ï].
• Enters the time entry mode.
2. Push [MW] to move the cursor forwards, or push
[MODE] to move the cursor backwards to select a
digit to enter.
3. Rotate [DIAL] to enter the time.
• Range: Set to between 00:00:00 and 23:59:59.
4. Repeat steps 2 and 3 to enter the time.
5. After entering, push [ï].
5. Entering the GPS Memory latitude
1. Select "LATITUDE," then push [ï].
• Displays the LATITUDE screen.
2. Push [MW] to move the cursor forwards, or push
[MODE] to move the cursor backwards to select a
digit to enter.
3. Rotate [DIAL] to enter the latitude.
• Range: Set to between 0°00.00' to 90°00.00'.
L You can change the unit to "ddd°mm'ss"." (p. 9-64)
L To enter a north latitude, select "N," and to enter a
south latitude, select "S."
4. Repeat steps 2 and 3 to enter the latitude.
5. After entering, push [ï].
6. Entering the GPS Memory longitude
1. Select "LONGITUDE," then push [ï].
• Displays the LONGITUDE screen.
2. Push [MW] to move the cursor forwards, or push
[MODE] to move the cursor backwards to select a
digit to enter.
3. Rotate [DIAL] to enter the longitude.
• Range: Set to between 0°00.00' to 180°00.00'.
L You can change the unit to "ddd°mm'ss"." (p. 9-64)
L To enter an east longitude, select "E," and to enter a
west longitude, select "W."
4. Repeat steps 2 and 3 to enter the longitude.
5. After entering, push [ï].
7. Entering the GPS Memory altitude
1. Select "ALTITUDE," then push [ï].
• Displays the ALTITUDE screen.
2. Rotate [DIAL] to select between plus and minus.
3. Push [MW] to move the cursor forwards, or push
[MODE] to move the cursor backwards to select a
digit to enter.
4. Rotate [DIAL] to enter the altitude.
• Range: Set to between –32808 and +32808 feet.
5. Repeat steps 3 and 4 to enter the altitude.
6. After entering, push [ï].
8. Selecting the GPS memory group
1. Select "GROUP," then push [ï].
2. Select the group between (No Group) and A ~ Z.
L A total of up to 300 memories can be saved.
5-28
☞ Continued on the next page