Course; Speed - Icom ID-4100A Advanced Manual

Previous view
9
MENU SCREEN
GPS items (Continued)
Position
GPS > GPS TX Mode > D-PRS > TX Format > Object
> Position
Displays the position information of the Object.
Push [QUICK] to open the window shown below.
TIP: When you select "Capture From GPS" or "Set
From GPS Memory," you can capture the position
from the GPS, or set the Object's position from the
GPS memory. (p. 5-18)
Entering the latitude
1. Rotate [DIAL] to select "Edit," then push [ï].
• Displays the POSITION EDIT screen.
2. Select "LATITUDE," then push [ï].
• Displays the LATITUDE screen.
3. Rotate [DIAL] to enter the latitude.
L Push [MW] to move the cursor forwards, or push
[MODE] to move the cursor backwards.
L To enter a north latitude, select "N," and to enter a
south latitude, select "S."
4. After entering, push [ï].
Entering the longitude
5. Select "LONGITUDE," then push [ï].
• Displays the LONGITUDE screen.
6. Rotate [DIAL] to enter the longitude.
L Push [MW] to move the cursor forwards, or push
[MODE] to move the cursor backwards.
L To enter an east latitude longitude, select "E," and to
enter a west longitude, select "W."
7. After entering, push [ï].
Entering the altitude
8. Select "ALTITUDE," then push [ï].
• Displays the ALTITUDE screen.
9. Rotate [DIAL] to select between plus and minus.
10. Push [MW] to move the cursor forwards.
11. Rotate [DIAL] to enter the altitude.
L Push [MW] to move the cursor forwards, or push
[MODE] to move the cursor backwards.
12. After entering, push [ï].
13. Select "<<Write>>," then push [ï].
• The confirmation dialog "Write?" is displayed.
14. Select <YES>, then push [ï].
• Writes the entered position data.
15. Push [].
TIP: The number of characters you can enter
in "Comment" differs, depending on the "Data
Extension" and "Altitude" settings.
After entering the position data
Data Extension
GPS > GPS TX Mode > D-PRS > TX Format > Object
> Data Extension
Select whether or not to transmit the Course/Speed
data or Power/Height/Gain/Directivity data along with
the position data in the D-PRS mode.
• OFF: Does not transmit any information.
• Course/Speed: Transmits the Course and Speed
data along with the position data.
• Power/Height/Gain/Directivity:
Transmits the Power, Height, Gain
and Directivity data, along with the
position data.
Only the Icom transceivers, ID-
51A/E PLUS, ID-51A/E PLUS2,
ID-5100A/E, and ID-4100A/E, can
receive Power, Height, Gain and
Directivity data. (As of April 2017)
TIP: The number of characters you can enter
in "Comment" differs, depending on the "Data
Extension" and "Altitude" settings.

Course

GPS > GPS TX Mode > D-PRS > TX Format > Object
> Course
Set the Object's course to between 0º and 360º.
L This item is displayed when "Data Extension" is set
to "Course/Speed."

Speed

GPS > GPS TX Mode > D-PRS > TX Format > Object
> Speed
Set the Object's speed to between 0 and 1150 mph.*
* If the Speed unit is set to "km/h," select between 0 to 1850
km/h, or set to "knots," select between 0 and 999 knot.
(p. 9-64)
L This item is displayed when "Data Extension" is set
to "Course/Speed."
9-29
(Default: OFF)
(Default: 0º)
(Default: 0mph)