Altitude - Icom ID-4100A Advanced Manual

Previous view
9
MENU SCREEN
Menu items and Default settings (Continued)
NOTE: The default settings shown in bold letters below are for the USA version.
The default settings may differ, depending on your transceiver version.
Display Unit
Latitude/Longitude
Altitude/Distance
Speed
Temperature
Barometric
Rainfall
Wind Speed
Display Language
System Language
Sounds
Beep Level
Key-Touch Beep
Home CH Beep
Band Edge Beep
Scan Stop Beep
Standby Beep
Scope AF Output
Time Set
Date/Time
DATE
TIME
GPS Time Correct
UTC Offset
Auto Power OFF
DV Gateway
<<Terminal Mode>>
<<Access Point Mode>>
* The default value may differ, depending on the transceiver version.
ddd°mm.mm' or ddd°mm'ss"
m or ft/ml*
km/h, mph*, or knots
ç or ƒ*
hPa, mb, mmHg, or inHg*
mm or inch*
m/s, mph*, or knots
English or Japanese
English or Japanese
Sets the Sound options.
0~9
OFF or ON
OFF or ON
OFF or ON
OFF or ON
OFF, ON, ON (to me:High Tone),
or ON (to me:Alarm/High Tone)
OFF or ON
Sets the Time options.
2000/01/01~2099/12/31
0:00~23:59
OFF or Auto
–14:00~±0:00~+14:00
OFF, 30min, 60min, 90min, or
120min
Enters the Terminal mode or Access Point mode.
9-12
Selects position format to display the position.
Selects the units to display the distance and

altitude.

Selects the units to display the speed.
Selects the units to display the temperature.
Selects the units to display the barometric
pressure.
Selects the units to display the rainfall.
Selects the units to display the wind speed.
Selects the display language in the DR
screen or MENU screen. When "English" is
selected in "System Language," this item is
not displayed.
Selects English or Japanese as the system
language of the transceiver.
Sets the beep output level.
Turns the confirmation beep tones ON or OFF
when key is pushed.
Turns the Home CH Beep ON or OFF.
Turns the Band Edge Beep ON or OFF.
Turns the Scan Stop Beep ON or OFF.
Turns the Standby Beep function in the DV
mode ON or OFF.
Selects the audio output option during a
sweep.
Sets the current date.
Sets the current time.
Sets to automatically correct the time using a
GPS signal.
Enters the time difference between UTC and
the local time.
Turns the Auto power OFF function ON or
OFF.
Enters the Terminal mode.
Enters the Access Point mode.