Icom ID-4100A Advanced Manual page 153

Previous view
9
MENU SCREEN
Menu items and Default settings (Continued)
NOTE: The default settings shown in bold letters below are for the USA version.
The default settings may differ, depending on your transceiver version.
Remote MIC Key
During RX/Standby
During TX
Up/Down MIC Key
During RX/Standby
During TX
One-Touch PTT(Remote MIC) OFF or ON
PTT Lock
Busy Lockout
Time-Out Timer
Active Band
MIC Gain
Data Speed
CI-V
CI-V Address
CI-V Baud Rate
CI-V Transceive
CI-V Bluetooth➝REMOTE
transceive Address
Power OFF (With No
Controller)
Display
LCD Backlight Brightness
LCD Backlight Color
Key Backlight Brightness
Key Backlight Color
* The default value may differ, depending on the transceiver version.
[F-1]:MODE [F-2]:Monitor
[F-1]:T-CALL [F-2]:---
[UP]:UP [DN]:DOWN
[UP]:--- [DN]:---
OFF or ON
OFF or ON
OFF, 1min, 3min, 5min, 10min,
15min, or 30min
Single or All
1~2*~4
4800bps or 9600bps
02h~9Ah~DFh
4800, 9600, 19200, or Auto
OFF or ON
00~DFh
OFF or ON
Sets the Display options.
1~4
White, Amber, Green, or Blue
1~4
White, Amber, Green, or Blue
9-10
Selects the key function for [F-1] or [F-2] on
the supplied remote-control microphone.
Selects the key function to be used while
receiving or in the standby mode.
Selects the key function to be used while
transmitting.
Selects the key function for [UP] or [DN] on
the optional hand microphone.
Selects the key function to be used while
receiving or in the standby mode.
Selects the key function to be used while
transmitting.
Turns the One-Touch PTT function ON or
OFF.
Turns the PTT Lock function ON or OFF.
Turns the Busy Lockout function ON or OFF.
Selects the Time-Out Timer time options.
Enables continuous frequency selection
across all bands by rotating [DIAL].
Sets the microphone sensitivity to suit your
preference.
Selects the data transmission speed for
low-speed communication, or between the
[DATA] jack and external modules like a GPS
receiver, and so on.
Sets the transceiver's unique CI-V
hexadecimal address code.
Sets the CI-V code transfer speed.
Turns the CI-V Transceive function ON or
OFF.
Sets the address to inhibit the external control
with CI-V for the transceiver through the [SP]
(REMOTE) jack.
Selects whether or not to automatically turn
OFF the transceiver when the controller is
disconnected from the transceiver.
Selects the LCD backlight brightness level.
Selects the LCD backlight color.
Selects the key backlight brightness level.
Selects the key backlight color.