Resetting The Cpu; D Partial Reset; D All Reset - Icom ID-4100A Advanced Manual

Previous view
10
OTHER FUNCTIONS

Resetting the CPU

Occasionally, erroneous information will be displayed
when, for example, first applying power. This may
be caused externally by static electricity or by
other factors. If this problem occurs, turn OFF the
transceiver. After waiting a few seconds, turn ON the
transceiver again. If the problem is still there, perform
a Partial reset or an All reset.

D Partial Reset

Others > Reset > Partial Reset
1. Push [MENU].
2. Rotate [DIAL] to select "Others," then push [ï].
3. Select "Reset," then push [ï].
4. Select "Partial Reset," then push [ï].
• The confirmation dialog "Partial Reset?" is displayed.
5. Select <YES>, then push [ï].
• When the partial reset is completed, "PARTIAL
RESET" is displayed, then the display automatically
returns to the default screen.
L A Partial reset resets the operating settings to their
default values (VFO frequency, VFO settings, menu
contents) without clearing the items below:
• Memory channel contents
• Scan Edge contents
• Call channel contents
• Call sign memories
• Message data
• DTMF memory contents
• GPS Memory contents
• Repeater list
NOTE for the All reset:
After you perform an All reset, you cannot use the
DR function because the repeater list will be cleared.
So we recommend you save the setting data onto
a microSD card, or to your PC using the CS-4100
cloning software before performing an All reset.
After the All reset is finished, load or write the saved
data into your transceiver.

D All Reset

Others > Reset > All Reset
1. Push [MENU].
2. Rotate [DIAL] to select "Others," then push [ï].
3. Select "Reset," then push [ï].
4. Select "All Reset," then push [ï].
• The confirmation dialog "All Reset?" is displayed.
5. Select <NEXT>, then push [ï].
• The confirmation dialog as shown below is displayed.
6. Select <YES>, then push [ï].
• After the All reset is finished, the default screen is
displayed.
L An All reset clears all setting, and returns all
settings to their factory defaults. Therefore, the
repeater list, Memory channel contents, filter
settings and so on will be cleared, so you will
need to reenter your memories, list and operating
settings.
10-18