Changing The Qso Recorder Settings - Icom ID-4100A Advanced Manual

Previous view
7
VOICE MEMORY

Changing the QSO recorder settings

You can change the recording setting on the MENU
screen.
See page 9-21 for details.
Record only the received audio
Voice Memo > QSO Recorder > Recorder Set >
REC Mode
L The default setting is "TX&RX" (Both transmitted and
received audio are recorded).
Continue to record even while the squelch is
closed
Voice Memo > QSO Recorder > Recorder Set >
RX REC Condition
L The default setting is "Squelch Auto" (Records only while
the squelch is open).
Record the QSO audio as one file
Voice Memo > QSO Recorder > Recorder Set >
File Split
L The default setting is "ON" (transmitted and received
audio are separately recorded in different files).
L When "RX REC Condition" is set to "Squelch Auto," an
audio file is created every time the squelch opens. The
received audio is recorded in a separated file.
Synchronize the recording to PTT
Voice Memo > QSO Recorder > Recorder Set >
PTT Auto REC
L The default setting is "OFF" (Recording is not
synchronized to PTT.).
TIP: When "PTT Auto REC" is set to "ON"
• Starts recording not only when PTT is pushed,
but also when switched to transmit by the CI-V
command.
• When "REC Mode" is set to "RX Only," the transmit
audio is not recorded.
• A signal that is received within 10 seconds after the
squelch is closed is recorded in same file.
Change the Skip Time
Voice Memo > QSO Recorder > Player Set >
Skip Time
L The default setting is "10sec."
7-4