Setting The Supported Radius Server Type; Setting The Status Of Radius Servers - H3C S9500 Series Operation Manual

Operation Manual – AAA RADIUS HWTACACS
H3C S9500 Series Routing Switches

1.4.6 Setting the Supported RADIUS Server Type

Follow these steps to set the supported RADIUS server type:
Enter system view
Create a RADIUS scheme
and enter RADIUS
scheme view
Specify the RADIUS
server type supported by
the device
Note:
If you change the type of RADIUS server, the data stream destined to the original
RADIUS server will be restored to the default unit.
When a third-party RADIUS is used, you can configure the RADIUS server to
standard or extended. When CAMS server is used, you must configure the
RADIUS server to extended.

1.4.7 Setting the Status of RADIUS Servers

When a primary server, authentication/authorization server or accounting server, fails,
the device automatically turns to the secondary server.
After the status of a primary server stays blocked for a period specified by the timer
quiet command, the device tries to communicate with the primary server. If the primary
server has resumed, the device turns to use the primary server and stops
communicating with the secondary server. In this case, the status of the primary server
is active again and the status of the secondary server remains the same. After
accounting starts, the communication between the client and the secondary server
remains unchanged.
If both the primary server and the secondary server are in the state of active or blocked,
the device sends the packets only to the primary server.
To do...
system-view
radius scheme
radius-scheme-name
server-type { extended |
standard }
Chapter 1 AAA/RADIUS/HWTACACS Configuration
Use the command...
1-31
Remarks
—
Required
By default, a RADIUS
scheme named "system"
has been created in the
system.
Optional
By default, the supported
RADIUS server type is
standard. In the default
system scheme, the
default RADIUS server
type is extended .