Setting The Supported Radius Server Type; Setting The Status Of Radius Servers - H3C S7500E Series Operation Manual

Operation Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
Note:
The maximum number of retransmission attempts of RADIUS packets multiplied by
the RADIUS server response timeout period cannot be greater than 75.
Refer to the timer response-timeout command in the command manual for
configuring RADIUS server response timeout period.

1.4.6 Setting the Supported RADIUS Server Type

Follow these steps to set the supported RADIUS server type:
Enter system view
Create a RADIUS scheme
and enter RADIUS
scheme view
Specify the RADIUS
server type supported by
the device
Note:
If you change the type of RADIUS server, the data stream destined to the original
RADIUS server will be restored to the default unit.
When a third-party RADIUS is used, you can configure the RADIUS server to
standard or extended. When CAMS server is used, you must RADIUS server to
extended.

1.4.7 Setting the Status of RADIUS Servers

When a primary server, authentication/authorization server or accounting server, fails,
the device automatically turns to the secondary server.
When both the primary and secondary servers are available, the device sends request
packets to the primary server.
Once the primary server fails, the primary server turns into the state of block, and the
device turns to the secondary server. In this case:
If the secondary server is available, the device triggers the primary server quiet
timer. After the quiet timer times out, the status of the primary server is active
again and the status of the secondary server remains the same.
To do...
system-view
radius scheme
radius-scheme-name
server-type { extended |
standard }
Chapter 1 AAA/RADIUS/HWTACACS
Use the command...
1-27
Configuration
Remarks
—
Required
Not defined by default
Optional
By default, the RADIUS
server type is standard.