Removing And Installing Centre Differential Housing With Gearbox Removed - Audi A8 Workshop Manual

Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
7 - Flange shaft (rear)
❑ Removing and installing
❑ Renew oil seal when renewing flange shaft (rear)
❑ Select correct components from ⇒ Electronic parts catalogue
8 - Bolt
❑ Tightening torque and sequence
❑ Renew
9 - Ball bearing
❑ For centre differential
❑ ⇒ „2.3 Renewing ball bearing for self-locking centre differential", page 160
10 - Centre differential
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
11 - Gearbox
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
12 - Screw plug
❑ For oil filler hole on transfer box
❑ 20 Nm
❑ Renew
Centre differential housing - tightening torque and sequence
– Tighten bolts for centre differential housing in two stages as
follows:
1. Tighten bolts -1- and -2- initially to 3 Nm.
2. Tighten bolts to 16 Nm in sequence -1 ... 7-.
2.2 Removing and installing centre differen‐
tial housing with gearbox removed
Removing
Note
♦ General repair instructions
Rules for cleanliness when working on the automatic gearbox
♦
⇒ page 11
The centre differential housing can also be removed and in‐
♦
stalled with the gearbox in the vehicle ⇒ Automatic gearbox
09E, four-wheel drive; Rep. gr. 39 .
• Gearbox removed
• Secure gearbox to assembly stand
158
Rep. gr.39 - Final drive - front differential
⇒ „2.4 Renewing oil seal for flange shaft (rear)", page 161
⇒ page 158
⇒ page 1 .
⇒ page 18 .