Assembling Body „Ii - Audi A8 Workshop Manual

Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
5.7 Assembling body „II"
– Clip axial needle bearing -2- into sun gear „I" -item 3-.
• The closed side of the axial needle bearing faces towards sun
gear „I".
– Fit sun gear „I" -item 3- in planet carrier „I" -item 1-.
• The side with the axial needle bearing faces towards planet
carrier „I".
– Renew circlip -4-.
– Fit circlip -4- in planet carrier „I" -item 1-.
• The angled section -B- of the circlip must be located in the
recess directly next to planetary gear shaft -A-.
– Engage planet carrier „I" -item 1- on retaining plate of cylinder
„A" -item 2-.
• The toothed segments -item A- and -item C- must engage in
the retaining plate.
• The planetary gear shafts -item B- must be located directly
next to the holes in the retaining plate.
• The planet carrier „I" -item 1- should engage audibly.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
88
Rep. gr.37 - Controls, housing
with respect to the correctness of information in this document. Copyright by AUDI AG.