– Tighten bolts in sequence -1 ... 11-.
•
Tightening torque: 8 Nm
– Renew ATF strainer.
– Check whether seal is fitted on new ATF strainer.
– Fit ATF strainer on mechatronic unit.
– Clean magnets -1- and -2- in ATF oil pan.
– Ensure that magnets make full contact with ATF oil pan.
– Fit ATF oil pan with new gasket.
Gearbox with 24 bolts on ATF oil pan:
– With ATF oil pan removed, screw guide pins -T40199- into
positions -11, 12, 23 and 24-.
Note
The guide pins -T40199- hold the gasket and the ATF oil pan in
position. Without them the ATF oil pan will not be properly sealed.
– Guide new gasket and ATF oil pan over guide pins -T40199- .
– Tighten bolts for ATF oil pan in the sequence -1 ... 10-.
– Unscrew guide pins -T40199- .
– Tighten remaining bolts for ATF oil pan in the sequence
-11 ... 24-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
•
Tightening torque: 12 Nm
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
Audi A6 2005 ➤ , Audi A8 2003 ➤
2. Dismantling and assembling ATF supply unit
119