Audi A8 Workshop Manual page 114

Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
– Drive in torque converter oil seal with thrust piece -T10137-
until thrust piece reaches stop.
– Cover splines on flange shaft (left-side) -arrow- with insulating
tape to prevent damage to oil seal between final drive and
gearbox housing when inserting flange shaft. Take care to
cover the splines completely, without creasing or overlapping
the tape.
– Clean flange shaft (left-side) and oil seal between final drive
and gearbox housing.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Pack space between sealing lips of oil seal -arrow- half-full
with sealing grease -G 052 128 A1- .
Caution
While inserting the flange shaft (left-side), it must be held cen‐
trally to avoid damaging the oil seal between the final drive and
the gearbox housing.
– Insert flange shaft -A- into gearbox, guiding shaft centrally into
oil seal between final drive and gearbox housing -arrow-.
110
Rep. gr.38 - Gears, control