Removing And Installing Flange Shaft (Right-Side) With Gearbox Removed - Audi A8 Workshop Manual

9 - Bolt
❑ Note tightening torque
and sequence ⇒ page 127
10 - Cover for front final drive
❑ Removing and installing
11 - Shim
❑ Behind tapered roller bearing outer race
12 - Tapered roller bearing outer race
13 - O-ring for front final drive cover
❑ ⇒ „1.6 Renewing O-ring on cover for front final drive", page 134
14 - Differential
15 - Roll pin
16 - Gearbox selector lever
17 - Oil seal for selector shaft
❑ Renewing ⇒ page 155
18 - Bolt
❑ 23 Nm
19 - Flange shaft (left-side)
❑ ⇒ „1.3 Removing and installing flange shaft (left-side)", page 128
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
Cover for front final drive - tightening torque and sequence:
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
– Tighten bolts of cover for front final drive as follows.
Stage
1 – Tighten bolts -1- and -2- to 3 Nm.
2 – Tighten bolts -1 ... 11- to 23 Nm in the sequence
indicated.
1.2 Removing and installing flange shaft
(right-side) with gearbox removed
Special tools and workshop equipment required
♦ Used oil collection and extraction unit -V.A.G 1782-
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
⇒ page 134
with respect to the correctness of information in this document. Copyright by AUDI AG.
Tightening sequence
Audi A6 2005 ➤ , Audi A8 2003 ➤
1. Servicing front final drive
127