Audi A8 Workshop Manual page 34

Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
– Turn clutch „C/D" upside down.
• Axial needle bearing faces upwards.
– Using two small screwdrivers, unclip axial needle bearing -2-
from cylinder „C/D" -item 1-.
Note
-Arrow- can be disregarded.
– Detach plates of clutch „D" -item 2- from plate carrier of plan‐
etary drive „II" and „III" -item 1-.
– Detach flange washer -2- from planetary drive „II" and „III"
-item 1-.
– Turn gearbox on assembly stand.
• The ATF oil pan must face downwards.
Caution
Risk of damage to needle bearing.
♦ Take care when removing twin-lip oil seal for output shaft.
– Pry out twin-lip oil seal for output shaft using extractor tool -
T20143/2- .
– Check needle bearing behind oil seal for damage and renew
needle bearing if damaged.
30
Rep. gr.37 - Controls, housing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.