– Tighten bolts -arrows- on mounting bracket for flange shaft
(left-side).
•
Tightening torque: 23 Nm
2.3
Removing and installing ATF supply unit
Removing
– Secure gearbox to assembly stand
•
The gearbox must be horizontal with the ATF oil pan facing
downwards.
– Place used oil collection and extraction unit -V.A.G 1782- be‐
low gearbox.
– Remove ATF drain plug -arrow A- and allow ATF to drain off.
Note
Observe relevant disposal regulations.
♦
Some ATF always remains in the oil pan.
♦
-Arrow B- and -item C- can be disregarded.
♦
– Remove bolts -arrows- on mounting bracket for flange shaft
(left-side).
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
⇒ page 18
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A6 2005 ➤ , Audi A8 2003 ➤
2. Dismantling and assembling ATF supply unit
111