Audi A8 Workshop Manual page 74

Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
– Press dished spring down using workshop press with assem‐
bly jig -T10289- .
– Insert circlip -1-.
– Make sure that circlip is seated securely all round in groove
on retaining plate.
– Release workshop press.
– Insert corrugated spring -2- into cylinder „B" -item 1-.
– Fit outer plates -3- and friction plates -4- alternately.
– Insert thick outer plate -5-.
• Studded side of thick outer plate faces upwards towards circlip
– Insert circlip -6-.
70
Rep. gr.37 - Controls, housing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.