Self-Locking Center Differential; Center Differential, Removing And Installing - Audi Q5 2008 Repair Manual

Audi Q5 2008 ➤ , Audi Q5 China 2010 ➤
8-Speed Automatic Transmission 0BK AWD - Edition 04.2017
5

Self-Locking Center Differential

⇒ "5.1 Center Differential, Removing and Installing", page 176
For All Other Procedures on the Self-Locking Center Differential,
Refer to ⇒ Servicing - 8-Speed Automatic Transmission; Rep.
Gr. 39 ; Self-Locking Center Differential .
5.1 Center Differential, Removing and In‐
stalling
Special tools and workshop equipment required
♦ Engine and Gearbox Jack - VAS6931-
♦ Transmission Support - 3282-
♦ Protective Eyewear
Removing
• The transmission is installed.
Caution
Risk of damaging the transmission.
♦ Do not let the engine run or tow vehicle without gear oil.
Note
Pay attention to the general repair information. Refer to
♦
⇒ "3.3 General Repair Information", page 6
Pay attention to clean working conditions for the transmission.
♦
Refer to
⇒ "3.1 Clean Working Conditions, Guidelines", page 5
– Remove the rear noise insulation -2-. Refer to ⇒ Body Exte‐
rior; Rep. Gr. 66 ; Noise Insulation; Noise Insulation Removing
and Installing .
176
Rep. Gr.39 - Final Drive, Differential
.
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.