Audi A8 Workshop Manual page 119

– Check whether the existing shim -1- is still fitted on clutch „A".
– Apply puller for ATF supply unit -T40123- to stator shaft.
– Fit ATF supply unit in gearbox housing without O-ring at this
stage (turn ATF supply unit slightly in both directions).
• The opening on the housing of the ATF supply unit faces to‐
wards the ATF oil pan end.
– Detach puller for ATF supply unit -T40123- .
– Fit bolts -1, 2, 5, 9- for ATF supply unit with old sealing washers
and tighten bolts.
• Tightening torque: 10 Nm
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A6 2005 ➤ , Audi A8 2003 ➤
2. Dismantling and assembling ATF supply unit
115