Audi A8 Workshop Manual page 118

Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
– Detach adapter -B- for mechatronic unit.
– Pull out gasket -A- for ATF strainer (if it has not already been
removed together with the ATF strainer).
– Turn gearbox on assembly stand.
• The torque converter must face upwards.
– Slacken bolts for ATF supply unit in the sequence -14 ... 1-
and remove bolts.
– Remove bolts with sealing washers.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Apply puller for ATF supply unit -T40123- to stator shaft.
– Detach ATF supply unit.
– Detach O-ring from ATF supply unit.
Installing
Make sure that body „II" and clutch „B" are still correctly installed.
– Measure height of top edge of body „II" above contact surface
for ATF pump.
• Dimension -a- = approx. 12 mm
If dimension -a- is exceeded, body „II" or clutch „B" was pulled out
of engagement with plates upon removal.
– Remove body „II" and clutch „B" and then install again
⇒ page 33 .
114
Rep. gr.38 - Gears, control