Renewing O-Ring On Cover For Front Final Drive - Audi A8 Workshop Manual

Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
– Install bolts for cover for front final drive (observe specified
tightening torque and sequence)
– Install flange shaft (right-side)
– Install flange shaft (left-side)
1.6 Renewing O-ring on cover for front final
drive
Procedure
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
Note
with respect to the correctness of information in this document. Copyright by AUDI AG.
General repair instructions
♦
Rules for cleanliness when working on the automatic gearbox
♦
⇒ page 11
– Place used oil collection and extraction unit -V.A.G 1782- be‐
low gearbox.
– Remove flange shaft (right-side)
– Unscrew bolts in the sequence -11 ... 1- and remove cover for
front final drive together with outer race for tapered roller bear‐
ing and shim.
Note
The thickness of the shim has been measured to fit; the shim must
not be replaced with another shim of different thickness.
– Renew O-ring -arrow-.
Note the following if the outer race for tapered roller bearing and
the shim have dropped out of the front final drive cover:
– Lubricate shim and outer race for tapered roller bearing with
gear oil and insert in cover for front final drive as far as stop.
134
Rep. gr.39 - Final drive - front differential
⇒ page 127 .
⇒ page 127 .
⇒ page 128 .
⇒ page 1 .
⇒ page 127 .