Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
3.8
Dismantling and assembling planetary
drive „II" and „III"
Dismantling
Note
The planetary gear set cannot be renewed separately. The
♦
gearbox must be renewed if these parts are damaged.
The planetary gear set should only be dismantled for cleaning
♦
and assessment of wear
– Take sun gear „II" -item 3- out of planet carrier „II" and „III"
-item 1-.
– Unclip thrust washer -2- from sun gear „II" -item 3-.
– Apply internal puller 30 ... 37 mm -Kukko 21/5- by hand to sun
gear „III" -item 2-, as shown in detail view, and pull sun gear
„III" out of planet carrier „II" and „III" -item 1- by hand.
Note
The internal puller may only be applied below the teeth and not
close to the axial needle bearing.
– For re-installation, mark which axial needle bearing was clip‐
ped on at chamfer -arrow- on top of sun gear „III" -item 2-.
– If required, unclip axial needle bearings -1- and -3- from sun
gear „III" -item 2-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
62
Rep. gr.37 - Controls, housing
⇒ page 169
.