Audi A8 Workshop Manual page 166

Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
– Place cover -A- for self-locking centre differential on fitting tool
-T10136- .
Note
The peg in the middle of the tool is centred and faces upwards in
the cover. It serves as a guide and stop for press tool -T10136/1- .
– Lubricate outer circumference of seal with gear oil.
– Push new oil seal onto press tool -T10136/1- .
• Installation position: the open side of the seal should face the
cover.
– Insert press tool -T10136/1- with oil seal into cover from above.
Note
The peg of the thrust piece -T10136- serves as a guide from below
and also as a stop for press tool -T10136/1- .
– Drive in new oil seal onto stop (take care to keep oil seal
straight).
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Pack space between sealing lips -arrow- of oil seal half-full
with sealing grease -G 052 128 A1- .
162
Rep. gr.39 - Final drive - front differential