Audi A8 Workshop Manual page 93

– Place oil collector -2- on planet carrier „I" in clutch „A"
-item 1-.
• The pins on the oil collector must fit into the holes on planet
carrier „I".
– Place clutch „A" -item 1- with planet carrier „I" on support -
T10283- .
• The ATF pump end must face downwards.
– Clip axial needle bearing -3- onto clutch „E" -item 4-.
• The closed side of the axial needle bearing faces towards
clutch „E".
– Place clutch „E" -item 4- on planet carrier „I" in clutch „A"
-item 1-.
– Clip axial needle bearing -5- onto clutch „E".
• The closed side of the axial needle bearing faces towards
clutch „E" -item 4-.
– Allow inner plate carrier „E" -item 6- with intermediate shaft to
engage in all plates of clutch „E" -item 4- by lifting and turning
slightly as required.
– Lift inner plate carrier „E" -item 6- with intermediate shaft a few
millimetres and then let it drop to check that all the plates have
meshed.
♦ If you hear a metallic sound, all the plates have meshed.
♦ If you only hear a muffled sound, some of the plates have not
meshed.
– Clip axial needle bearing -2- into inner plate carrier „A"
-item 1-.
• The closed side of the axial needle bearing faces towards in‐
ner plate carrier „A".
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
Audi A6 2005 ➤ , Audi A8 2003 ➤
5. Dismantling and assembling body „II"
89