Audi A8 Workshop Manual page 149

– Renew O-ring -arrow- in cover for front final drive.
– Carefully install differential -arrow-.
– Install bolts for cover for front final drive (observe specified
tightening torque and sequence)
– If necessary, renew oil seal for flange shaft (right-side)
⇒ page 131 .
– Clean flange shaft (right-side) and oil seal.
– Install flange shaft (right-side)
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
After installing gearbox:
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Fill up with ATF and check ATF level ⇒ Automatic gearbox
09E, four-wheel drive; Rep. gr. 37 .
– Fill up gear oil in front final drive and check oil level ⇒ Auto‐
matic gearbox 09E, four-wheel drive; Rep. gr. 39 .
– Fill up gear oil in transfer box and check oil level ⇒ Automatic
gearbox 09E, four-wheel drive; Rep. gr. 39 .
Tightening torques
Component
Intermediate flange for front axle drive to gear‐
box
Housing for centre differential to intermediate
flange for front axle drive
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
⇒ page 127 .
⇒ page 127 .
Nm
23
⇒ page 157
Audi A6 2005 ➤ , Audi A8 2003 ➤
1. Servicing front final drive
145